My father and I ran sound for a NorthCountry Tour of Le Reve du Diable https://www.youtube.com/watch?v=KL-YhguJRMk My French is slightly less than it takes to get your face slapped. I took Spanish in school. 20 miles from the Quebec border. Not that bright. I was obviously looking forward, planning...

A man walks into a bar...

That lucky bastard.

mattpeneguy wrote: ↑Thu Apr 15, 2021 11:29 amimage.png

You forgot the bleach, the rubber gloves and a hatchet

You can use if / then statements in equations as others have mentioned. Nesting of these statements is possible, see the attached model. It may not be the most proficient way of doing it, but it'll get the job done to a certain extent.

I believe that there is a filter selection option available with the DraftSight software, allowing you to select only circles and/or arcs. Unfortunately, it is no longer free with a SWX subscription.

My late grandfather told me once that there are three types of people in this world, the ones that can count and the ones that can't.

Aside from the incessant whining from a couple of co-workers, I will usually be listening to anything easy (jazz standards, Coltrane, the Duke, Sinatra, Davis, Eagles, Diamond, Joel, the Beatles, ELO…), and then there are others times when I feel like it is time to take the lead out and listen to so...

I had used Inventor for about a year or so, and this goes back approximately 9 to 10 years. We had just been bought out, and the preferred 3D modeling software of the overtaking company was Inventor. We were using, and are still to this day, both Solidworks and AutoCAD, yes you read correctly, AutoC...

DAY 403 OF HAND SANITIZER USE.

Yep, sad to see the old platform put out to pasture. I was fairly new to the old forum, maybe three or four years, even though I have been an on and off SWX user pretty much since its inception in 95/96. It was only recently, the last couple of years that I had frequented it on a daily basis, either...

"Whatever you do, always give 100%. Unless you're donating blood"

Bill Murray

1. Depending on the complexity of the design I will either start with a sheet-metal feature or solid modeling and then convert to sheet metal. The more complex (multiple compounded angles) the more likely I am to start off with solid modelling and then convert to sheet-metal at the appropriate point...