Thank you everyone for responding, I found Dennis Bacon's wrap solution works the best for the situation. I was unaware the wrap feature could be used on any face. I previously thought it was reserved for cylindrical surfaces only. Although the edges are a little strange, I am almost certain I wont ...

Is this going to be a sheet metal part or machined? Neither actually. I'm just a high school senior that only has access to 3D printers. The part in question is just a case to hold my raspberry pi and a couple single-board cameras. The slots shown in the original post were supposed act as air vents...

Hey everyone. I'm relatively new to CAD so I do not know the in's and out's of Solidworks yet. For the last 30 minutes or so, I've been trying to "fold" a sketch over a 90 degree edge to make a somewhat complex (for me) extrude cut over two faces. The only google search results I've seen r...