Zebra Stripes
-
Maha Nadarasa
- Posts: 193
- Joined: Tue Mar 16, 2021 12:46 pm
- x 51
- x 48
Zebra Stripes
How to improve this Zebra Stripes? This is G1 relation between curve and surface. I tried with G2 and G3 relation but it did not work.
- Attachments
-
Extension Flap.SLDPRT- (208.11 KiB) Downloaded 55 times
-
When you work with surfaces keep in mind to select edges so you can apply tangency in the connections - Loft, Boundary and Fill, If I am not mistaken.
So in this case the easiest way is the Boundary Surface:
Go to full postSo in this case the easiest way is the Boundary Surface:
Re: Zebra Stripes
When you work with surfaces keep in mind to select edges so you can apply tangency in the connections - Loft, Boundary and Fill, If I am not mistaken.
So in this case the easiest way is the Boundary Surface:
So in this case the easiest way is the Boundary Surface:
- Attachments
-
- Extension Flap - Boundary Lucas.SLDPRT
- (123.17 KiB) Downloaded 63 times
Re: Zebra Stripes
Also changing the arc to spline:
- Attachments
-
- Extension Flap - Spline.SLDPRT
- (132.33 KiB) Downloaded 49 times
Re: Zebra Stripes
And increasing the degree of the spline you can start the spline curvature close to zero, making Curvature to Face possible. This is as far as I know for now .-.
- Attachments
-
- Extension Flap - Spline Curvature.SLDPRT
- (150.98 KiB) Downloaded 57 times
-
Maha Nadarasa
- Posts: 193
- Joined: Tue Mar 16, 2021 12:46 pm
- x 51
- x 48
Re: Zebra Stripes
@Lucas
Thanks for the help.
Thanks for the help.