Feature and Sketch not under one another?

[JMOS4]

Hi,

I have an Extrude Cut Feature that the sketch somehow let me drag the sketch out from under it like you would normally see, how do I get it back under the feature it created?

as you can see the 40 degree cut extrude has nothing under it when I try to expand the tree (should have Sketch196)

image.png (12.46 KiB) Viewed 620 times

in the past I have seen this happen and no idea on how to correct it or make it like you would normally see other than delete the feature and redo

Regards,
Jim

[mike miller]

You probably pressed Ctrl+T and activated Flat Tree Display. Press it again and it will include consumed features under the children.

[JMOS4]

Hi again,

Tried the Control T and it puts all the features and sketches apart but when I toggle it back nothing changes

CTRL T:

image.png (23.53 KiB) Viewed 614 times

CRTL T again

image.png (28.11 KiB) Viewed 614 times

seems to be only on that one feature, was fine after I created it and had a pattern I was trying to drag up in a folder and all of a sudden noticed this

Regards,
Jim

[Lucas]

I have tried to replicate this, but only could let it be unabsorbed using the freeze bar.
Maybe it is due to the parent relation in the feature or maybe a bug? I didn't find a way to unabsorb one specific sketch :/