![Confused :?](./images/smilies/icon_e_confused.gif)
We are trying to setup our bom table as follows: The part configuration grouping is set to Display configurations of the same part as separate item all time.
This grouping setting could not be changed due to our PDM requirement....
However, in some cases, I would like to have some specific part "grouped", even though they have different configuration.
For example, i have 3 same cable ties (eg: CableTie.sldprt) in the assembly that is modelled as different configuration to show different "wrapping" diameter, so instead of showing them as separate item, I would like to have them group under the same item, (BOM setting should not be changed)
Current thoughts:
A bad workaround that I can think of now is to form a subassembly (eg: CableTie.sldasm) to include all 3 cable ties (CableTie.sldprt), and then have the quantity overwrite in BOM. User will first insert the cable tie in the assembly like normal then move the cable tie into an empty assembly using drag and drog
Doing so will allow the bom to only show 1 line. If the same cable ties is also used at other assemblies, user can use the same subassembly (CableTie.sldasm) but different configuration... Other notes;
In CREO, there is something call "Flexible subassembly" that can act as a workaround for situation like this (mainly because the bom in CREO cannot group family table instance)
So... any idea/suggestion?