Simulation not running

[jaystew23]

For some reason when I run the simulation, the load is not acting on the cantilever. Can somebody point me in the right direction?

[Uncle_Hairball]

Try a pack 'n go on the part. Hopefully that will include the simulation and would allow us to look at what you're doing.

[AlexLachance]

You seem to be lacking elements inside your study.

[JSculley]

Your body has been set to rigid, which means it will not deform. A deformable body has the circled icon and gives the results like this:

A body set to rigid has the circled icon and results like yours:

To correct the problem, right click the body in the tree and select 'Make deformable':