Layer Mapping-Yeah I know 8(

[picturedrawerGSS]

Ok So I know layer mapping for DXF is borked most of the time, But I had it nailed down and its been working flawlessly for months.
Yesterday it just stopped working.

in a DRW, on a blank sheet I have my part view with a sketch that has its file name.
I would export to DXF and layer map "sketch lines" to the "etch" layer.

Everything is now on the zero layer with geometry....
Any suggestions?

[picturedrawerGSS]

uhh well I guess I fixed it. lower left hand corner is an option "only map entities....."
Must have sneezed and checked that box or something

[AlexLachance]

Maybe you aren't pointing to your mapfile anymore..?

[picturedrawerGSS]

Not sure, probably just the unusual jankyness going on.
it stop working
I checked that box, no effect.
Today I unchecked the box and it started working.
-Shrugs-