Assembly "Component Display" setting

[loeb]

I am trying to write some VBA that sets the "Component Display" of the assemblies and parts in an assembly to "Default Display". I was hoping to find a method in IComponent2, but am having no luck. Any advice is appreciated.

Thank You,

[RonE]

I think the official way is to use DisplayMode Property (IModelDocExtension).

However, much easier (and probably also working for you) is to use that:

swApp.runcommand 2567, ""

Just preselect the desired components and then run that command.

[loeb]

Thank you, RonE. That worked great!