Please Create a PowerMill Board on Here!!!

[tk421]

The Autodesk PowerMill forum is borderline unusable. I would like to see two PowerMill boards on here after the fashion of the old Delcam forum: One board for general PowerMill questions, one board for PowerMill macros and automation.

Please join me in asking the Admin of this site for this by leaving a post on this thread.

Thanks!

David Adam
<><

[standardpattern]

I would second this.

Steve

[AlexLachance]

I doubt Matt would be against it if there is incentive towards it.

[Spadix]

I came here specifically to request a Powermill board

[tk421]

This is awesome! Thank you guys for signing up, and for visiting it! I will do my best to get other users over here to truly make it worth while and as successful as the Delcam forum was!

[Spadix]

This is awesome! Thank you guys for signing up, and for visiting it! I will do my best to get other users over here to truly make it worth while and as successful as the Delcam forum was!

Your post was what got my attention in the autodesk forums. Looking forward to it.

[tk421]

Awesome! Let's make this more successful than theirs!

[matt]

Awesome! Let's make this more successful than theirs!

That's what this place is all about!