Does anyone have a font for cutting words into sheet metal that they would be willing to share? The centers of the letters need to be connected to the outside so they don't fall out when cut, which is why I can't use a standard font. I did a quick search online but didn't come up with anything that had the centers of the letters connected to the outside.
Any help is much appreciated!
Font for Laser Cutting?
-
Jaylin Hochstetler
- Posts: 387
- Joined: Sat Mar 13, 2021 8:47 pm
- Location: Michigan
- x 380
- x 355
- Contact:
Font for Laser Cutting?
A goal is only a wish until backed by a plan.
Re: Font for Laser Cutting?
If you search for "stencil font" there are many to pick from.
-
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
Re: Font for Laser Cutting?
See if this works for youJaylin Hochstetler wrote: ↑Mon Apr 19, 2021 5:01 pm Does anyone have a font for cutting words into sheet metal that they would be willing to share? The centers of the letters need to be connected to the outside so they don't fall out when cut, which is why I can't use a standard font. I did a quick search online but didn't come up with anything that had the centers of the letters connected to the outside.
Any help is much appreciated!
- Attachments
-
- DXF & DWG.zip
- (31.7 KiB) Downloaded 994 times
-
- STENCILS.zip
- (631.74 KiB) Downloaded 1364 times
-
Jaylin Hochstetler
- Posts: 387
- Joined: Sat Mar 13, 2021 8:47 pm
- Location: Michigan
- x 380
- x 355
- Contact:
Re: Font for Laser Cutting?
Thanks for your help guys! I found one online that I attached.
- Attachments
-
- allerta.zip
- (2.04 MiB) Downloaded 1556 times
A goal is only a wish until backed by a plan.