Page 1 of 1
I'm new to the forum
Posted: Tue Nov 16, 2021 7:38 am
by adel pro
Now I share with you all this little modeling video of a piece on the Solid edge software.
the link to the video :
https://youtu.be/pdLKMEDqCX8
cordially
Re: I'm new to the forum
Posted: Tue Nov 16, 2021 11:00 am
by bnemec
link looks bad. note the .be in youtu
Re: I'm new to the forum
Posted: Tue Nov 16, 2021 11:12 am
by Tom G
bnemec wrote: ↑Tue Nov 16, 2021 11:00 am
link looks bad. note the .be in youtu
OP's Link resolves fine for me. This address convention is normal for YT videos when share linked.
Re: I'm new to the forum
Posted: Tue Nov 16, 2021 11:19 am
by bnemec
Tom G wrote: ↑Tue Nov 16, 2021 11:12 am
OP's Link resolves fine for me. This address convention is normal for YT videos when share linked.
My mistake.
Re: I'm new to the forum
Posted: Tue Nov 16, 2021 11:26 am
by Glenn Schroeder
Welcome to the forum.
Re: I'm new to the forum
Posted: Tue Nov 16, 2021 11:28 am
by matt
bnemec wrote: ↑Tue Nov 16, 2021 11:00 am
link looks bad. note the .be in youtu
I followed the link. It's legit. Actual SE Content. Not very good, and in mumbled french, but it's legit.
Re: I'm new to the forum
Posted: Tue Jan 11, 2022 2:32 am
by JuTu
Welcome to the forum!
Youtube shortens links when Share-feature is used to format "
https://youtu.be/[content code]"