HOLE WIZARD ERROR
HOLE WIZARD ERROR
So I always find it odd that SW can show you the preview of what you want and yet still spit an error at you. In todays example I am doing a simple grease zerk hole. Preview shows what I want and I still get a error code? Am I doing something wrong or is SW just being a pain?
- Attachments
-
-
Glenn Schroeder
- Posts: 1520
- Joined: Mon Mar 08, 2021 11:43 am
- Location: southeast Texas
- x 1758
- x 2129
Re: HOLE WIZARD ERROR
Can you show the previous page of the Hole Wizard property manager? Or at least check to make sure you have the correct body selected?
"On the days when I keep my gratitude higher than my expectations, well, I have really good days."
Ray Wylie Hubbard in his song "Mother Blues"
Ray Wylie Hubbard in his song "Mother Blues"
-
DanPihlaja
- Posts: 846
- Joined: Thu Mar 11, 2021 9:33 am
- Location: Traverse City, MI
- x 810
- x 978
Re: HOLE WIZARD ERROR
Also, you don't necessarily need the tangent plane for the hole. You can place hole wizard holes on the sides of cylinders. Then constrain them like any 3D sketch.
-Dan Pihlaja
Solidworks 2022 SP4
2 Corinthians 13:14
Solidworks 2022 SP4
2 Corinthians 13:14
Re: HOLE WIZARD ERROR
I get a similar error if the plane is below the face of the cylinder.
-
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams