CAD Forum

Is there any way to change the precision of numbers shown in custom property manager?

I've changed the precision of dimensions in document options and the dimensions shows as it should be:
- -
But linked dimensions to custom properties still shows as dual precision.
- -
Is there to make SW shows these numbers with single precision (10.0 - 8.4 - 6.0)?

thanks.

You need to change the precision under Units settings.

@gupta9665 you're a star.
Million thanks.

This one gets me once in a while when I get a part not done on my templates.

TTevolve wrote: ↑Mon Jul 25, 2022 12:54 pm This one gets me once in a while when I get a part not done on my templates.

This one gets a lot of people also.

that is one of those that you know it's there, but don't use it enough to remember where it is! At least for me since I rarely use fractions.