Does anyone have any skinny as to why NX and SE interoperation-compatibilities now seem to be stuck? Creo-compatibility has apparently been keeping current (or at least SW says so, I'm not a regular Creo user), but NX has been at 1899 and SE has been at 2020 since SW2021, with no change in SW2022 and SW2023.
Cheers
Jim
3D Interconnect NX/SE version lag
Re: 3D Interconnect NX/SE version lag
When we started with SW and PDM 2019 it would not work with most of the SE files that had been saved in 2019. Interconnect would just crash SW when importing a SE 2019. The directive of "always keep 3D Interconnect turned off" went out pretty quick and is now SOP.
PDM preview will not preview the files, puts up a tiny dialog that user must click OK before moving on. In general, having the latest SE version when going to SW just caused a lot of problems.
PDM preview will not preview the files, puts up a tiny dialog that user must click OK before moving on. In general, having the latest SE version when going to SW just caused a lot of problems.