how to unfold this section?
Posted: Fri Mar 10, 2023 2:24 am
Hi guys
how to unfold this section Sheet metal part?
how to unfold this section Sheet metal part?
Page 1 of 1
Re: how to unfold this section?
Posted: Sat Mar 11, 2023 10:37 am
Use the Blank Body command to flatten it.
Re: how to unfold this section?
Posted: Sun Mar 12, 2023 9:22 am
Re: how to unfold this section?
Posted: Sun Mar 12, 2023 9:46 am
the twist section seems not to be faltten in solidedge.
Re: how to unfold this section?
Posted: Sun Mar 12, 2023 11:49 am
Re: how to unfold this section?
Posted: Sun Mar 12, 2023 9:47 pm
That's great and i also made it, thanks!
Re: how to unfold this section?
Posted: Wed Mar 22, 2023 12:44 pm
SW geeks, how would you do this in SW? How would you flatten a bend like that in SW. I don't think it's possible in SW...
Re: how to unfold this section?
Posted: Thu Mar 23, 2023 10:00 am
Good question @Jaylin Hochstetler ,,, I'm impressed with the Solid Edge sheet metal capabilities. Going to have to get a trial version and immerse myself into it. In SW I would make two 3d sketches and do a lofted bend.
I don't think either SE or SW gives you quite what you would expect, but probably the overall length is fairly close. If this part was accomplished with a twisted rectangular blank it probably would look more like this.