Page 1 of 1
SolidWorks Feature Propertymanager doesn't reset
Posted: Thu Mar 30, 2023 12:37 pm
by BrianHoerner
Folks,
Were are on SW2022, seems that every time we create a feature, i.e. fillet, the settings that are chosen stick for each new created feature of that type until you change it again, even after reboot.
for example, if we pic a face fillet, close the fillet command allowing it to take affect. The next time we add a fillet the face fillet option is pre-selected.
i don't remember doing that in previous versions...
Any ideas or thoughts?
Thanks,
Brian
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Thu Mar 30, 2023 2:03 pm
by AlexLachance
BrianHoerner wrote: ↑Thu Mar 30, 2023 12:37 pm
Folks,
Were are on SW2022, seems that every time we create a feature, i.e. fillet, the settings that are chosen stick for each new created feature of that type until you change it again, even after reboot.
for example, if we pic a face fillet, close the fillet command allowing it to take affect. The next time we add a fillet the face fillet option is pre-selected.
i don't remember doing that in previous versions...
Any ideas or thoughts?
Thanks,
Brian
I've seen a lot of people asking for this to be implemented over the years, perhaps it was done as a setting? I didn't really see anything speaking about it
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Thu Mar 30, 2023 2:15 pm
by BrianHoerner
I am sure I am just not looking in the right place for the setting, I also had seen folks asking for this not too long ago, just don't remember them implementing it, I haven't seen anything in the SW knowledge base either...yet
appreciate the response!
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Thu Mar 30, 2023 3:52 pm
by DanPihlaja
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Fri Mar 31, 2023 12:42 pm
by BrianHoerner
Hey Dan,
Thanks, I do remember seeing that, just didn't remember where, appreciated...
Do you know of any way to turn a switch to stop this action?
Thanks again sir!
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Fri Mar 31, 2023 1:53 pm
by Glenn Schroeder
BrianHoerner wrote: ↑Fri Mar 31, 2023 12:42 pm
Hey Dan,
Thanks, I do remember seeing that, just didn't remember where, appreciated...
Do you know of any way to turn a switch to stop this action?
Thanks again sir!
I'm pretty sure you can't.
Re: SolidWorks Feature Propertymanager doesn't reset
Posted: Fri Mar 31, 2023 2:23 pm
by DanPihlaja
BrianHoerner wrote: ↑Fri Mar 31, 2023 12:42 pm
Hey Dan,
Thanks, I do remember seeing that, just didn't remember where, appreciated...
Do you know of any way to turn a switch to stop this action?
Thanks again sir!
I don't think that you can, as far as I know. I looked through the settings and couldn't find anything.