Page 1 of 1
cylinders are not parallel
Posted: Mon Apr 12, 2021 5:09 pm
by Assis As
i am trying to do mates in assembly , during that i am facing error in mates , how to resolve this
Thank you
Re: cylinders are not parallel
Posted: Mon Apr 12, 2021 5:15 pm
by mike miller
Can you upload your file? My crystal ball is dusty today.
Re: cylinders are not parallel
Posted: Tue Apr 13, 2021 3:41 am
by Assis As
THANK YOU for reply , i did again mates , but problem facing the assembly is fully defined cant move , please see the file
the linkage should move by hydraulics
thank you
Re: cylinders are not parallel
Posted: Tue Apr 13, 2021 4:58 am
by Per Engberg
The problem lies in your sketches for the base. They should be fully constraind, there are lines not parallel which should be.
Edit: Just checked the other parts, same problem there. Try going through a couple of tutorials - at least the basic ones. It will help you at lot.
Re: cylinders are not parallel
Posted: Tue Apr 13, 2021 10:58 am
by Assis As
Thank you very much yes I edit base and other parts , perfectly moving