CAD Forum

Anyone have AUTOSKETCH from autodesk?

Had someone ask to have a native file SKD converted to DXF. this is on Practical Machinist site. I trying to help them out.

it was killed off in 2008 by AD, check the forum for answers.

never hurts to try and see here because you guys know alot of s h i t!

if not no biggy, thanks all

lenny

Perhaps you could have some luck sending them to the guy in this thread

https://forums.autodesk.com/t5/autosket ... 204#M13977

crosby_a@hotmail.com

AlexLachance wrote: ↑Wed Jul 17, 2024 10:22 am Perhaps you could have some luck sending them to the guy in this thread

https://forums.autodesk.com/t5/autosket ... 204#M13977

crosby_a@hotmail.com

i did

Frederick_Law wrote: ↑Wed Jul 17, 2024 10:35 am https://www.autodesk.com/support/techni ... ormat.html

I don't think Len has access to AutoSketch

AlexLachance wrote: ↑Wed Jul 17, 2024 10:54 am I don't think Len has access to AutoSketch

Then it's done.

Copies of autosketch 10 are available on etsy for a reasonable price. (Assuming it is legit.)

no I don't have, was someone on Practical Machinist Forum, was hitting up here just in case, never know if you don't ask.

thanks to all I found the same stuff and forward it to the OP on PM, he doesn't use a computer, does drafting he was helping someone else, went south fast, thats what I get for teying to help