Coincident but not merged points...?
Posted: Fri Apr 23, 2021 3:29 pm
Hi all,
The attached screenshot is the error message that I got when I tried to use a sketch to make an extruded cut offset from a curved surface. Could it be because the selected surface is curved? Also attached the file to the post.
Any help/insight is appreciated .
Thanks in advance,
The attached screenshot is the error message that I got when I tried to use a sketch to make an extruded cut offset from a curved surface. Could it be because the selected surface is curved? Also attached the file to the post.
Any help/insight is appreciated .
Thanks in advance,